Split Core Brush Quote
Straight brush strips are locked into an aluminum core to form a rotary brush with a paddle-wheel effect. This construction creates a flicking action and allows the brush to conform to irregular surfaces. The design allows easy brush installation without removing the drive shaft or bearings.
|Core Type||Core Diameter||Maximum Fill||Alternative Fills Avail|
|TJ-16||2″||16 Strips||4 or 8|
|TG-20||5″||20 Strips||5 or 10|
|TH-36||5″||36 Strips||9, 12 or 18|
Note : Split-Core Cylinder Brushes are not recommended to run over 500 RPM. The illustration depicts 5″ diameter core brush flange mounting.
Please give all dimensions in inches and indicate any critical tolerances.